Jump to content

rasnodgrass

Puppy Poster
  • Posts

    7
  • Joined

  • Last visited

Everything posted by rasnodgrass

  1. I appreciate your input. I will check on this with the shop. Thanks
  2. I assume the guys at the shop did but can't say for sure. Just know they tried pulling it after the starting attempt failed and rear tires would not roll. Not sure if clutch was depressed
  3. I own a 1962 B61T with an endt 673. Shop was idling truck checking for air leaks when motor shut down on its own as if you had shut it down. No type of unusual noise noticed. When trying to restart would not crank over and battery terminals became red hot. Further inspection determined that something had locked up everything including the drive train. Tried pulling but rear tires were locked.Any suggestions or advice would be greatly appreciated. Thanks
  4. What gauge wire is used to replace wiring on 1962 B61T? I am needing to run new wiring for headlights turn signals tail lights etc.
  5. I am currently restoring a 1962 B61T. Currently the air brake tubing is copper. What is the preferred/required replacement tubing to be used? I will be using the truck for show and recreational use.
  6. Thanks for the response. I appreciate it. It is a 1962 B61T single axle with RAD-1141 CRD-62 rear.I will try to provide pictures
  7. Where can spring bushings for b model Mack be found? I need replacements for rear springs
×
×
  • Create New...