DAVID MACK
-
Posts
5 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Posts posted by DAVID MACK
-
-
that's the "Intake Air Temp Sensor".
thank you for your help
-
Hello, I am getting a code 23 out of the lightning bolt on my 2000 mack vision?
thanks for the previous help on the circut breakers.
-
If the lightning bolt light is on, you can turn off the cruise control and press and hold the set/decel button to get the code. The lightning bolt will flash, pause, then flash some more. Count the number of flashes.
For example, one I see from time to time is "blink blink blink blink (pause) blink" would be a 4-1 code...which on my '01 CH is for the Vehicle Speed Sensor. Another is "blink (pause) blink blink blink"....or the 1-3 code for the fuel temp sensor.
There may be more than one code...and once it has run through all of the codes causing the light to be on, they'll repeat. Not sure if it's necessary or not, but I usually keep holding the set/decel until I've seen 'em all and they start repeating.
If the codes don't tell 'em what's wrong, it'll at least give 'em a jumping off point for where to start looking.
thanks i will check it out
-
have a mack vision getting the lightning bolt light and then truck shutting off. now truck will start but not keep idle
was told could be a bad circut breaker? its not the coolant sensor thanks for your help
Fuel Probllem Mack Vision
in Engine and Transmission
Posted
Hey everyone: replaced the circut breaker to the vcu she fired ran great then died. I dont see any fuel in the water seperator
now she just cranks hard with a code 23 thanks to all who have been helping me.