Jump to content

ford444

Puppy Poster
  • Posts

    9
  • Joined

  • Last visited

Posts posted by ford444

  1. Hello everone I drove my b61 with the endt673c engine. It ran slugish between 1800 and 2100 rpm.So I took my injector pump off the end673 170hp engine changed the govener because turbo and natural aspirated engine are dfferent. I installed it on my 250hp engine turn the pump up a little It runs really good now but wondering if i cut the hp of the engine. Local shop wants $2100 to rebuild pump.

    Thanks for any help ford :mack1:

  2. can anyone tell me how to remove the piston from the power cylinder on my r600?the service manual said see ross cylinder overhaul but it has 3 bolts on the end of the cylinder????thanks adrian

    Adrian Take the 3 bolts out and theres a snap ring inside you have to take out little tricky to get out should be a tiny hole in the top of cylinder to push ring down so you can pull it out. let me know if this helps.

  3. I was looking into later down the road to take out 20 speed quad box and installing a newer mack 9 or 10 speed mack transmission wondering if anyone has done this swap and what i'll need to do? My setup is endt673c engine with single clutch, but do have flywheel for double clutch setup. I know I'll have too make trans mounts and extend drive shaft but not sure what other modifications I'll have to do. My rear ends are 3.87 ratio with 22.5 low pro tires. :mack1:

  4. As far as I know, the CDL laws are mandated by federal law and are the same state to state. It should list your limitations on the back of your license. But it goes by the GVWR of the vehicle and what the vehicle was designed for, ie commercial vehicle. So if the GVWR (gross veh weight rating) is above 26,000 lbs, you need a class B CDL and if you add a trailer with a GVWR over 10,000 lbs, you then need a CDL A.

    Vehicles manufactured as motorhomes/campers got exempted from this cause of a strong lobby effort.

    Thanks guys for the help. I talk to a couple of drivers and they told me to license it as a motor home and put NOT FOR HIRE on the truck until I Do the driving test. also stay under 26,000 I'm planning to use truck for commercial use in the future. Pics of my truck in process of the build are in my album check it out. :mack1:

×
×
  • Create New...