Jump to content

dlkkms

Puppy Poster
  • Posts

    11
  • Joined

  • Last visited

Posts posted by dlkkms

  1. I have a 2005 Mack Vision has 740,000 miles At road speed the engine just cuts out and then comes back. It was missing and cutting out a couple of weeks ago put it in the shop they Found #2 and #3 unit pumps logging fault codes replaced also turbo was leaking oil out the back replaced and cleaned inter cooler. Been running truck but still cutting out also smokes bad too under low acceleration like its loading up not sure about egr related???? Also several months back broke fan clutch plug off does anyone know where I could get one besides replacing???? It also shows some weird codes like injector 13 and fuel control valve awhile back and engine management.

  2. I have a 2005 Mack Vision CX612 single axle no engine brake has 740,000 miles At road speed the engine just cuts out and then comes back. It was missing and cutting out a couple of weeks ago put it in the shop they Found #2 and #3 unit pumps logging fault codes replaced also turbo was leeaking oil out the back replaced and cleaned inter cooler. Been running truck but still cutting out also smokes bad too under low acceleration like its loading up not sure about egr related???? Also several months back broke fan clutch plug off does anyone know where I could get one besides replacing????

  3. I have a 2005 Mack Vision has 740,000 miles At road speed the engine just cuts out and then comes back. It was missing and cutting out a couple of weeks ago put it in the shop they Found #2 and #3 unit pumps logging fault codes replaced also turbo was leeaking oil out the back replaced and cleaned inter cooler. Been running truck but still cutting out also smokes bad too under low acceleration like its loading up not sure about egr related???? Also several months back broke fan clutch plug off does anyone know where I could get one besides replacing????

  4. Check for boost and exhaust manifold leaks first . Any leaks on these engines will cause issues . Any malfuction lite codes? Oil in the front side of Turbo is coming from air compressor intake piping and is normal for older trucks.

    the electronic log shows

    128 14 - 5 MID 128 (Engine), SID 14, Injector Cylinder # 14, FMI 5, Current below normal or open circuit 1 128 3 - 8 MID 128 (Engine), SID 3, Injector Cylinder # 3, FMI 8, Abnormal frequency, pulse width,

    the bolt comes on the dash once in a while also engine fan runs all the time I checked exhaust and boost hoses not seeing anything unless I'm missing something

  5. I have a 2005 Vision CX612 its smoking a lot of black smoke under acceleration seems to be worse at low speeds. It will smoke heavy until it clears out at road speed no big power lose and pulls fairly well under load boost pressure goes up to 25 to 30 and drops back. Truck has over 700k pulled front boot of front of turbo and is wet with black stick sludge in air cleaner tube. Not sure if this is causing problem. It also seems to puff out dark smoke going down the road.

×
×
  • Create New...