One bad dog

What would cause injector lines to leak coming out the heads

Thanks

Can anyone tell me the tricks to remove door panel so I could repair window crank on 89 r model thanks

Thanks guys

Can anyone tell me the shift pattern on t2090 thanks

I had put a used crank and balancer

Right behind second main cap on throw same place as last time.i ran the truck years hauling dirt no problems started haul sugarcane and broke two cranks in the same place. Thanks

Right behind second main cap on throw same place as last time.i ran the truck years hauling dirt no problems started haul sugarcane and broke two cranks in the same place. Thanks

That's what I was thinking too thanks

Yep 300 maxidyne

What will cause a crankshaft to break that's two cranks broke in same place thanks

Will a flywheel from an e7 work on a e6 motor. Would anyone know if they balanced the same. Thanks

Thanks cuz I noticed around 1900 it feels like it just ain't pulling anymore looks like it gets up better if I shift it around 1800rpms thanks

Does anybody know the torque band on a em6 300

Thanks

What's the difference between em6 an a e6

Does anybody know if e7 4 value rocker arms can b used in an e6 4 value motor thaks

Thanks to all my buddies that tried to help me the first machine that I took the heads to was closing my heads was the last ones they did . I had no problems before they went there put heads on and the problem was there took heads yesterday to another machine shop he called me this morning he found the problem the first machine shop drilled straight threw the head when they was taking out the freeze plugs on back of the head on number 6 cyl straight threw about a 1/4 in hole perfect hole he said he repaired the head and pressure tested it I torgued them on this evening with some new Mack gaskets I will let yaull know how she runs tommorrow evening once again thanks to everybody for the advice thank u

There was no rubber seals on old r new gaskets all bolt holes was clean I checked that thanks

I think the water got into the intake when I rolled the motor over alittle with the wrench I think it was two pistons that was up didn't have no water but the ones that was down had water so I pulled the injectors so I could roll the motor over I have soaked all the cylinders w d 40 thanks

Everything matched had gasket all right with top on top old gaskets didn't have little notch by first and last head bolt on each head but I looked at Mack gaskets they had same little notch as the pai ones I put now I didn't c no water jacket seal rings that is what it is open flow somewhere cuz I never cranked engine just put water in radiator and it went straight to the pistons cuz it didn't go through the block cuz water was clear no antifreeze and block had antifreeze in it thanks any info will help this is first time this happened to me heads was all fine before this just had alittle bitty sweep taught it might b freeze plug between head so pulled heads and now this problem thanks

I never took out r messed with liners just heads and gasket

No water in pan I never crank the motor all gaskets and fire ring all look like they got squeezed real good I took heads back to shop to have them pressured tested again looks to me when I put the water in radiator it went right on the pistons this on has really got me thanks alot for the info guess I,ll see what this shop saids about heads I know heads was good when I took them off it's crazy thanks again

The cylinders was full like I would have just poured the water right in the cylinder never seen this before

All