-
Posts
2 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Posts posted by alwaysmack
-
-
I had the same problem with the AD9. On the side of the dryer there is a half inch plug, take it out. Inside you will see a plastic X shaped pin, take it out. There is a spring attached to it. on the other end should be a small O ring. Mine was gone. Replace this O ring . Problem solved. PS I couldn't find one so I made one. from a rubber washer.
Vision no power, overheating
in Engine and Transmission
Posted
I had similar problem with my 460, only worse. Couldn't get more than 30 mph empty. Fuel transfer pump was the problem. The gear that drives the pump is plastic and pressed onto the shaft. Over time it wears out and slips on the shaft. My truck was a 2000 CX they may have corrected that problem with the newer models but worth a look.