Jump to content

Recommended Posts

I have now replaced the RPM Guage cable on my CF 3 times.  Each time it works fine for about two hours and then the tang breaks off in the Guage itself.  I have replaced the guage, and obviously the cable.  Any ideas what could be causing this??

Link to post
Share on other sites

Did you just replace the inside drive cable or both the drive cable and the housing for the cable   I always put a little oil or light grease in the cable housing

Edited by mrgumby
Link to post
Share on other sites
22 hours ago, mrgumby said:

Did you just replace the inside drive cable or both the drive cable and the housing for the cable   I always put a little oil or light grease in the cable housing

I replaced both and I put oil on the drive cable inside the housing.  I am guessing there is a process for this but I can't find anything that makes sense...

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...