Randyman Posted September 14, 2019 Share Posted September 14, 2019 B I U ☺️ Quote Link to comment Share on other sites More sharing options...
Mack Technician Posted September 14, 2019 Share Posted September 14, 2019 Start with initial problem/code/failure/etc. 1 Quote Link to comment Share on other sites More sharing options...
Randyman Posted September 15, 2019 Author Share Posted September 15, 2019 Gives 128-022-2 sid,,timing sensor inconsistent/ irratic reading 128-021-8 sid engine position sensor Any help in what/ where to check is greatly appreciated, put in new sensor,, not real good at electrical issues. Quote Link to comment Share on other sites More sharing options...
Mack Technician Posted September 15, 2019 Share Posted September 15, 2019 Generally it’s checking sensor depth setting, ohms, tip condition and cleaning clutch metal off magnetic tip of flywheel sensor. Quote Link to comment Share on other sites More sharing options...
turckster Posted September 26, 2019 Share Posted September 26, 2019 There is an inconsistent signal between the cam and engine position sensors. The most likely cause is the flywheel ring has moved. You should be able to unplug one or the other sensor and the engine should run, may take some cranking to start though. There is a procedure to check if the notched position has moved on the flywheel but right now I can't find it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.