Jump to content
Triggerhappy

Need help with ENDT676 sleeve

Recommended Posts

I'm working on an ENDT676, engine was out of framed a year ago. It developed a cracked head so we pulled it apart to fix. Found 2 sleeves that can be moved by hand. The question I have is, are the sleeves supposed to be interference fit, or how tight should they be? The block was cut for .010 over sleeves, 4 of them are tight but two move. Azny help would bed appreciated. Have had no luck so far finding what the block bore should be compared to the sleeve outer diameter.

 

Thanks!

Share this post


Link to post
Share on other sites

The spec for liner fit in the bore is .002" loose to .001" tight. Liners moving while rotating the engine is nothing to worry about. If they do move, make sure no debris or crud gets under the liner flange. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Welcome to BMT!

...The world's best antique, classic & modern Mack Truck support forum! Founded in 2000, BigMackTrucks.com is the place to go for everything related to Mack Trucks!

BMT!

BigMackTrucks.com is owned and operated by Watt's Truck Center, New Alexandria, PA. This forum and it's contents are not affiliated with Mack Trucks, Inc. or Volvo Trucks North America.

×