Korman Trucking 0 Posted July 30, 2017 Share Posted July 30, 2017 Hi, My dad and I are scratchin our heads over this issue. We put new seals in our power steering pump a week ago, since then its been getting harder and harder to steer. We jacked the truck up with the motor off and armstronged the steering, then we started it up to compare. It was easier to steer without the motor running. We have heard rumors of adjustments on the relief valve or poppet valve. We cannot find either on the truck. Any info would be appreciated to guide us to a fix. Thank You Quote Link to post Share on other sites
theakerstwo 853 Posted August 8, 2017 Share Posted August 8, 2017 I have a tee that goes in the pressure line to the gear box and a 3000 psi gauge to check it with.This will tell you if the pump is dead or not.I would say the pump is dead but that is just a guess. Quote glenn akers Link to post Share on other sites
BC Mack 795 Posted August 9, 2017 Share Posted August 9, 2017 most of the manufacturers have on-line manuals that have fault finding charts... have you established pump pressure, other than the seals what else did you disturb to do the work? pinched line or blocked filter needs basic diagnosis first before you go deep into surgery BC Mack Quote Link to post Share on other sites
kscarbel2 4,733 Posted August 9, 2017 Share Posted August 9, 2017 You didn't mention which of the two possible gears you had, nor your axle size. But this info should suffice. TRW - HFB64 Service Manual https://www.trwaftermarket.com/globalassets/na/trucksteering---literature/steeringgears-lit/steeringgears-sm/hfb-64/hfb64.pdf Sheppard - 92 Series Service Manual http://www.rhsheppard.com/wp-content/uploads/2014/08/92_Series_Service_Manual.pdf 1 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.