Jimmy Mack Posted May 23, 2017 Share Posted May 23, 2017 All the Mack electronics gurus. I am re powering a crane with a Mack E7 electronic with an Allison transmission ( its in a garbage truck now). What electronics or sensors can I eliminate (if any), or rework the wiring harness to make it work in the crane? When we get this one figured out, I am doing 2 more. Any advise will be appreciated! Thanks in advance Quote Link to comment Share on other sites More sharing options...
theakerstwo Posted May 23, 2017 Share Posted May 23, 2017 None and you need to use the mack truck wiring harness for the engine and trans.Sorry to bear bad news but its not a easy task. Quote glenn akers Link to comment Share on other sites More sharing options...
Jimmy Mack Posted May 23, 2017 Author Share Posted May 23, 2017 Thanks Glenn, I was afraid of that. But we will just take our time. Quote Link to comment Share on other sites More sharing options...
fjh Posted May 23, 2017 Share Posted May 23, 2017 (edited) 12 hours ago, Jimmy Mack said: Thanks Glenn, I was afraid of that. But we will just take our time. 12 hours ago, Jimmy Mack said: Thanks Glenn, I was afraid of that. But we will just take our time. Yup just hollow out the packer take all of it wire and both ecu s Edited May 23, 2017 by fjh Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.