Jump to content

Recommended Posts

This is my first post here but have been lurking for a while.  I've got a 95 RD690 with a E7 400 electronic pump.  Bought the truck a few months ago and had some issues when we bought it.  Have fixed everything except the power issue.  We think the engine is in limp mode.  The truck starts and idles fine.  But it has no power whatsoever.  We've checked for boost leaks.  Installed a pyrometer and boost gauge. 15 psi boost on a hard pull and pyrometer doesn't get any hotter than 5-600 degrees.  The speed sensor is not hooked up and we can't find the speedometer wires going back under the truck (no twisted wires).  My question is can I just not run 2 wires from the speed sensor and tie into the ecm or the harness somewhere?  And if so what wires to splice into.  Any help is greatly appreciated.

Link to post
Share on other sites

If enabled in the ECM programing. If you have no speedo signal it goes into limp mode. The wires go to the ECM  and then out of ECM to the speedo head. Wires numbers ontop of the trans should be 11-F-16 and 11-G-16

Link to post
Share on other sites
  • 4 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...