Jump to content
JerryB

Forgot how to flash code

Recommended Posts

Could somebody refresh me on how to do a flash code on my 1998 CH613 ?  Its been so long since I had a problem I've forgotten how to code it.

 

Problem is the engine spins fine with starter but does not crank & run.  It will crank right up and run fine with a push start

Share this post


Link to post
Share on other sites

You can check your codes with the cruise control switch's, but you must have a stored code (ie, CEL stays on) You do itby having key on, cruise power switch off, and hold RESUME/ACCEL switch on until CEL light goes out. The light will start flashing the codes. It'll be a two digit #, with a slight pause between seperate codes.

Share this post


Link to post
Share on other sites

Aim to please

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...