Search the Community
Showing results for tags 'trans and engine'.
Found 1 result
I recently installed a en401 in my b42, it has a 5-2 duplex. the engine went together with the transmission incredible well. it bolted together with no problem. however now there is no clutch pedal at all, you can push the clutch pedal and it does nothing, if you turn the engine over with the trans in gear the engine turns over freely and the truck does not move. I am stumped as the engine and the trans bolted together with no trouble and it appeared the splines slid together easily. I am thinking perhaps the spline on the 5-2 was smaller than the clutch disk and is now just spinning inside. are all the splines on these transmissions the same? is there something i may have missed? I hate to pull it apart again. any suggestions?