Search the Community
Showing results for tags 'fuel filter'.
FYI I looked on here for the info and never found it so I decided to post. Just changed oil and filter last night in my 1958 B61 with the 673END Wix/Napa numbers Oil Filter 1554- uses the smaller Luberfiner 500 canister, drain plug on bottom with copper washer 15/16", vent bolt on top, holds about a 1.5 gallon of oil. ((Inspect copper washer for damage, this is what prevents the plugs from leaking)) <<<<The O-Ring is the same for both the 500 and the 750 housings>>> The part number is -Luberfiner 2788, Fleet Guard(Cummings) 101853S, NAPA FIL 5414 Remove plug at bottom and drain, remove band clamp, pull filter out, clean and inspect inside housing and rubber gasket, replace drain plug, replace with new filter, fill with oil, replace top cover and secure with band clamp and crack open vent. Drain engine oil and refill, holds 15 qrts or just under 4 gallons check you dip stick Start engine observe oil pressure and tighten vent. Check for leaks, don't over tighten Fuel Filter 3090- canister mount right front engine. Remove line from top fitting, then turn nut on top and remove, remove filter and clean canister, replace filter and fill with about pint of fuel just to the top of the filter, oil and install rubber gasket, retighten cover, install fuel line. Start engine let idle for a few minutes and you should have no problem with air. Check for leaks,dont over tighten. Local NAPA has the Oil Filter for $21 Fleet Filter is $10.95 http://www.fleetfilter.com Fuel Filter is $13.49 and Fleet Filter is $6.99, I am sure you could check Oreilly or Carquest but I buy 99% of my filters from Fleet Filter, I figure out my filter needs for the year and buy 1,2 or 3 of each depending on equipment or vehicle, that saves lots of money. Rob