Jump to content

Search the Community

Showing results for tags 'fuel filter'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • The Lobby
    • Introduction Forum
    • Truck Stories
  • General Discussions
    • Antique and Classic Mack Trucks General Discussion
    • Modern Mack Truck General Discussion
    • Mack Truck Q & A
  • Specific Topic Forums for Antique & Modern Trucks
    • Engine and Transmission
    • Driveline and Suspension
    • Air Systems and Brakes
    • Electrical, Electronics and Lighting
    • Exterior, Cab, Accessories and Detailing
    • Fire Apparatus
  • Odds and Ends
    • Odds and Ends
    • Trucking News
    • Other Truck Makes
    • Tractors and Equipment
  • Market Place
    • For Sale
    • Wanted to Buy
    • Feedback Forum
    • Transportation Board
    • Watt's Truck Center
    • Product Announcements & Group Buys
  • Shows and Events
    • Truck Shows and Events
  • Site Related
    • Site Related Topics
    • BMT Wiki Support Topics
    • Test Forum
  • Test Club's Post


There are no results to display.

There are no results to display.


  • Antique & Classic Mack Truck Articles
    • Antique & Classic Mack Info
    • Antique Tutorials and How-To Articles
    • Antique Parts and Service Suppliers
  • Modern Mack Truck Articles
    • Modern Mack Truck Info
    • Modern Tutorial and How-To Articles
    • Modern Parts and Service Suppliers
  • Bulldog Magazine


  • Antique Mack Trucks 1900-1949
  • Classic Mack Trucks 1950-1989
  • Modern Mack Trucks 1990-Present
  • Other Makes

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Spam Protection




Other Trucks

Found 1 result

  1. FYI I looked on here for the info and never found it so I decided to post. Just changed oil and filter last night in my 1958 B61 with the 673END Wix/Napa numbers Oil Filter 1554- uses the smaller Luberfiner 500 canister, drain plug on bottom with copper washer 15/16", vent bolt on top, holds about a 1.5 gallon of oil. ((Inspect copper washer for damage, this is what prevents the plugs from leaking)) <<<<The O-Ring is the same for both the 500 and the 750 housings>>> The part number is -Luberfiner 2788, Fleet Guard(Cummings) 101853S, NAPA FIL 5414 Remove plug at bottom and drain, remove band clamp, pull filter out, clean and inspect inside housing and rubber gasket, replace drain plug, replace with new filter, fill with oil, replace top cover and secure with band clamp and crack open vent. Drain engine oil and refill, holds 15 qrts or just under 4 gallons check you dip stick Start engine observe oil pressure and tighten vent. Check for leaks, don't over tighten Fuel Filter 3090- canister mount right front engine. Remove line from top fitting, then turn nut on top and remove, remove filter and clean canister, replace filter and fill with about pint of fuel just to the top of the filter, oil and install rubber gasket, retighten cover, install fuel line. Start engine let idle for a few minutes and you should have no problem with air. Check for leaks,dont over tighten. Local NAPA has the Oil Filter for $21 Fleet Filter is $10.95 http://www.fleetfilter.com Fuel Filter is $13.49 and Fleet Filter is $6.99, I am sure you could check Oreilly or Carquest but I buy 99% of my filters from Fleet Filter, I figure out my filter needs for the year and buy 1,2 or 3 of each depending on equipment or vehicle, that saves lots of money. Rob
  • Create New...