Jump to content

terry

Pedigreed Bulldog
  • Posts

    2,197
  • Joined

  • Last visited

  • Days Won

    1

Everything posted by terry

  1. You also have to use a shorter nosed water pump, and shorter crank hub. terry
  2. Just be sure to run a die on each end of studs and run a bottom tap and blow out stud holes on block. Terry
  3. Leak in return line will let it bleed off. does that supply pump have the two little plastic check valves? if one is bad no pumping fuel. terry
  4. Wow they made the B model later there than the U.S. terry
  5. His has coolant water through it along with the air, yours is an older air only model. Terry.
  6. Them are later tanks than he his looking for, might work with a little fabrication of brackets. terry
  7. Data plate says ST, six wheel, tractor. Terry
  8. We’re all kicking ourselves on cars that we sold when we were young! Terry
  9. Are you supposed to put harder valve seats in an older engine with the unleaded gas now? Terry
  10. Probably be a lot cheaper to fix the exhaust. Terry
  11. Do you have the middle seal out, seems to me there was a lip in there to press middle seal against. Been along time since I had one of them apart! Terry
  12. Definitley a new one on me! terry
  13. He said no air shift, the 2060,2070 and 2080 all had an air low range flipper on the stick. Terry
  14. I was always told if you started it without the lock in it would loosen the clutch 🤷‍♀️
  15. can,t say that I have, I was a Mack dump owner, driver for 40 plus years, so most of my work was on my own truck. I would help in the shop for the company that I worked for once in a while , seems like his mechanic would use a rattle gun with a long bit to knock a stuck one loose. Terry
  16. This is a new one on me to adjust. terry
  17. Don’t know what kind of clearance you have there, but sometimes you can just slide trans. Back and do your clutch work. Terry
  18. To many guys try to use silicone and squeezes the gasket out. terry
  19. I think the stand I have you have to use the oil cooler with it, it has two hard lines with o rings between cooler and stand, I’ll have to dig it out and take a look. Terry
  20. A agree with joeys system on a few more pounds of torque one time and run, I have seen guys do that without a problem. Terry
  21. I tried that once, the return side stayed way higher than the suction side. Apparently the crossover hose wouldn’t even it out fast enough. Terry
×
×
  • Create New...