Tommy Mason
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
BMT Wiki
Collections
Store
Everything posted by Tommy Mason
-
When connecting the Nexiq interface, I can see in the "Device Tester" that the interface is reading the modules but, the VMAC software says that it is not connected. I have tried changing the various settings on the interface but when I take it off J 1708, it quits reading the modules and will not do anything. Please help.
-
Thanks
-
Thanks for the reply. I found the tool you mentioned at a couple of different places and some of those vendors advertise that the h ring can be installed from the crankcase with this tool...is this true? And, they are saying another tool, J-46083, is needed to check alignment after installing the h ring. Does the installation tool hold the h ring so that it will be aligned properly during installation?
-
I have a 1999 e-tech 350 with a bad cam and 3 lifter rollers that are flat. Looking up at the h ring on the lifers that failed, it looks like the h ring is turned a little bit causing the lifter to not be flat on the lobe as it should be. What is the procedure to replace the h ring? And how do you determine the proper place to set it in the block? It looks to me like it would take a special tool to set it the right height.
BMT Forum Logo
