Jump to content

Luke4780

Puppy Poster
  • Posts

    4
  • Joined

  • Last visited

Everything posted by Luke4780

  1. I have a 05 cv 713. With the E7 It will crank but no start ran fine a couple days ago. Went to start it, and it started, ran for a couple seconds, and died. Just like you turned the ignition off. No spit no sputter. It will run on either. Until the either runs out. Then it dies. have new clean fuel in it. Have fuel coming to the injector units. Took my ECU off and put it on another truck, and it ran it. So my ECU is good. I’ve checked all fuses and relays(that i know of). Checked both cam and crank sensors. They’re good. Already checked my hot wires and grounds. Pulled the kick panel off the passengers side and checked for any corroded plugs on the vecu. They’re all nice and clean. I’m at a loss here. Any help would be appreciated.
  2. Shouldn’t be the fuel shutoff valve. I have fuel all the way to the atom module. Is there another module, that tells the atom module to open up and let fuel into the filter? And I’m using a computer and doing a forced Regen. And i haven’t tried it for 15 minutes. I figured if it was sparking inside the filter i should have fuel too. But didn’t. I’ll do another. Forced Regen and let it do it for 15 minutes and see if it starts dosing fuel.
  3. I have fuel pressure to the atom module. The fuel pump down there is working properly. I don’t have fuel going through it.
  4. Hey guys, i need some help. Can’t get this truck to Regen. It’s an 09 Mack le with an mp7. I’ve got fuel and air to the atomization module. And got fire inside the particulate filter. But no fuel getting to it. I don’t know what module let’s that atomization module open up and let fuel into the filter. I’ve tried 3 different atomization modules on this truck. And all of them do the exact same thing. I have fuel going to it. But not through it. And i have air coming through it. And i have spark in the filter. Any help would be greatly appreciated
×
×
  • Create New...