Jump to content

Truck Shop

Pedigreed Bulldog
  • Content Count

    622
  • Joined

  • Last visited

  • Days Won

    30

Truck Shop last won the day on November 11

Truck Shop had the most liked content!

Community Reputation

1,145 Excellent

About Truck Shop

  • Rank
    BMT Forum Guru

Profile Information

  • Interests
    diesel trucks of all types

Previous Fields

  • Make
    Mack
  • Model
    B75
  • Year
    1960

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Does the shifter move fore and aft when you let off the fuel or accelerate slightly? More than likely main shaft end play? Would be my thought.
  2. Should be a E-6 valve, sure you don't have the ports mixed up? you have supply going to delivery-Supply should be IIRC 11 and delivery 12- on primary and secondary supply 21 and delivery 22. IIRC
  3. One other thing I used was Bostik 1100 urethane/adhesive to hold the weather striping in the register tracks and the two vertical seals in the vent windows. Those were originally riveted but using the 1100 and letting it set 24 hrs you can't tear them out. We use the 1100 to patch the inside of our refer trailer walls. When it drys it's stuck for good.
  4. A mechanic I know on another forum took that photo. He works in the Atacama Desert at a mine in Chile.
  5. Whats that behind me?
  6. One extra thing to help besides using tape. I used duct tape around the rolled edge of the opening in the door then smeared a thin layer of Napa brand Sil Glyde on the duct tape. The registers slid right over the tape/ no scratches.
  7. On the early FRO's the shift fork in the rear section was held in place with a snap ring, those are known to break. You will have to remove the transmission and remove the top cover/shift bar housing. You will be able to see the shift fork and shift bar. Snap ring goes on end of shift bar. It's a simple fix. I have repaired several for that problem.
  8. If your talking about the 1/2 hole in the dash, that will just get a chrome push-in plug, And yes the cab is off frame and that hole in floor is for clutch pedal.
  9. H67ST I bought the insulation off Ebay, it was the best price I could find. https://www.ebay.com/itm/Heat-Proof-Insulation-Killer-Sound-Deadener-Mat-Classic-Cars-Truck-Automobiles-/174087580510
  10. Dash finished, go to work on the doors. the headliner is being covered with gray diamond tuck.
  11. Well here's where I let the cat out of the bag because several of you wish that you had my time. I'm salaried at work and run the shop, when the work is done, parts ordered and the shop cleaned I work on the 75 til the next job shows up. The boss doesn't care, I work seven days a week so something gets done on the 75 everyday.
  12. The outer covering on the Heat sound suppressor material is a heavy {mylar/foil} covering. There is nothing to short out wires on, non conductive. Now the tape I used to cover the seams is Aluminum foil duct tape. But I'm not to worried about fires or the like. Actually I'm more concerned about a meteor hitting it.😉
  13. With cab and fenders removed and frame basically stripped, I went over my B75 with wire brush and scraper and never found any thing that resembled a serial number. And mine has the B cab.
×
×
  • Create New...