Black Rock Fab

7.49 to much. I need something around 3.73-4.56

Hey guys not sure if anyone can help me or point me in the right direction on this. I tried doing search's but haven't found anything yet. So I'm looking to use a mack center for a custom axle I'm building. My main concern is what were the axle shaft diameters used over the years? I seen some websites selling them stated some were just under 2inch while others were around 2.25". Anyone know of a lighter duty axle with around 1.625"? Thanks for any help

Naybe even a smaller one like a RA23R?

also any photos? thanks kyle

I just need the center sections so the suspension donts really matter. How much are you asking? thanks kyle

Hey guys im new to the site and im looking for a rear Aluminum top loading Center section (acutally looking for 2 matching ones) gear ratio im kinda open on. But i can always chage it later on. Also dont need the whole housing just the center itself. Dont need power devider or anything like that. Thanks Kyle