Jump to content

r600

Bulldog
  • Posts

    150
  • Joined

  • Last visited

Everything posted by r600

  1. can anyone tell me how the kysor alarm unit works,my unit has 4 wires on one side and one on the other,on the side with 4 wire top wire 12 volts,next is water level,next is 12 volts out to light and buzzer have 12 volts all the time????the 4 ?????on the side with 1 wire its got 2 green wire one sender rear water sender other maybe oil presure buts this terminal has 4.7 volts when key is on??????disconneted these wire and it 4.7 volts out of the alarm unit????????help please
  2. hey the rain stopped got out there and found 3 senders in the water manifold the one on the top of the manifold has had the wire cut???when i earthed the other two senders the temp gauge did nothing???earthed the water level sender and no joy.any help????
  3. thanks to all how have relpyed,havent had time to check anything yet but as soon as the rain stops(its a public holiday and it raining)i will check the senders,fullfuel01 do you have a picture of the controller unit???or anyone ,oz trucks may have it in a different place if know what it looks like that will help ,thanks again adrian
  4. hey all,can anyone tell me what works the shut down light?is it oil pressure switch,water temp sender???my light is staying on all the time,has oil presure!thanks adrian
  5. hey barry tank part number is 2mb4810rp1 thanks again barry
  6. can anyone tell what part number tank strap i need for square 55 gallon tank??thanks adrian
  7. hey skip needed you 2 weeks ago,but what i did was where the cut out for the drain is cut about 10 mm out andit fits,thanks again to all help,adrian
  8. does anyone know how to get a built sheet for aussie trucks???thanks adrian
  9. thanks too all the guys for your help.the bloke i got the plate from said they went on the outside but didnt seam to fit???will let you know how i go,thanks again adrian
  10. can anyone tell me is this fitted right someone said its ment to go on the outside of the stemco cap???thanks adrian
  11. can anyone tell me can you still buy the custom built for horn button asked my local mack dealer but like all young blokes thats to hard,or can you just get the gold part with custom built for and put it into my horn button,if anyone had part number that help greatly,maybe barry can help,thanks again adrian
  12. after being viewed by 107 people ,no person has any pictures,does this mean know one has a custom built mack truck???????adrian
  13. does anyone have a picture of a custom built r-model horn button????cheers adrian
  14. fjh,had the pump off my truck ,and the new gasket from mack already had the gasket make that way so i didnt have to modify it,cheers adrian
  15. does anyone have dimensions of original mack bull bar or any pictures of bull bar to suit r600,thanks adrian
  16. hey rob ,are you trying to pop the tie rod end off the hub or remove the tie rod end from the tie rod??if your trying to pop the tie rod off the hub can you put a long bar over the top of the tie rod and under the axle and get someone(maybe daughter)to pull down,if possible put 2 jaw pull on the tie rod end and give it heaps,then get that hammer while helper(daughter too pull down as you hit),good luck adrian
  17. hey grant ,my truck r685rst only has i battery box on the l/h side behind front wheel my truck is only a 12 volt system with 1 battery to run electrical system and air for the starter motor.maybe rob has electric starter motor or 24 volt system????cheers adrian
  18. i fitted new pai bonnet blinker less then 1 month ago but the chrome is going milky is this common???was anyone had the same problem????thanks adrian
×
×
  • Create New...