Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 05/12/2021 in all areas

  1. I got my treadle valve back today. I couldn't find one reman or new but I found Precision Rebuilders in Missouri will rebuild them for $187.00. The nice thing is they had it back to me in one week, so many other things I've had done take months to get back. It's a Bendix type D or D-1 (not sure which), part number is 223192.
    2 points
  2. If your buying new ! go where your service is going to be the best Most all makes are created equal ! All cheap wire all cheap sensors JUNK the base vehicle will be comparable! BUY lots of warranty you'll need it! My opinion
    1 point
  3. I think we're missing some more details. We don't have acknowledgement that hes releasing the parking brake. When did the truck roll last? Has it been sitting for a long time? What work did you have to do on it?
    1 point
  4. Looking at the second photo it looks like your chassis has been joined so I very much doubt thats original Paul
    1 point
  5. I believe that to be correct as well The whole show was a bit of a mess as a result Paul
    1 point
  6. It has some, but not as bad as I have seen. I don't think its too far gone
    1 point
  7. nothing big yet...I just ordered a 3-1 Etnyre but here is my west coast rackley hooked up to it. Probably end up with an 80 ton in the next couple years.
    1 point
  8. Too many projects, too little time 🙄😄 There are worse problems to have! Good news: Mack paint is DONE! Body assembly is happening THIS WEDNESDAY! I can't wait to finally see this old girl put together. It's a big step forward. Popped one side of the hood up there just for a visual and got really excited. Finally got my '62 Newport out, now that the weather is starting to come around. And the Freightliner transformation is (mostly) done. Hope I'm not doing too much "contamination" by including that before and after shot. 🤣
    1 point
  9. If i remember right, on some applications the snap ring is needed to hold the pilot bearing a little farther out to catch the input shaft. terry
    1 point
  10. what engine do you have mack gray engines have a snap ring!
    1 point
  11. 1 point
  12. Billy Mack gudday m8 Mack n Junk should nevr evr be used in the same sentance U could have an ol run down rusted mack .... but it can nevr B junk on the otherhand anything with Volvo on it iz junk from when its born till it goes on the scrap boat to China LOL WotSezU? cya
    1 point
×
×
  • Create New...