Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation since 02/20/2020 in Image Comments

  1. 1 point
    I will start by saying there are 6 LT's used to restore this one. There is over 3400 hours of labor that were put in by the previous owner and me so if you figure $20 an hour, no one would work on it for $20 an hour back then or now, that is $68,000 for labor. $25,000 to stipe to bare metal everything except frame and suspension and show quality repaint. Then there is the cost of the 6 donor LT's that averaged $9000 each, $54000 as the only way to get the parts was to get the whole trucks. Find an engine $2500, Rebuild that Supercharged 320 Cummins $10000. Imported 22 inch tube tires 10@$400, $4000. All total $163,500 I'll take half that for it $81,750 Went you want to come and get it? It took (6) B-75's to restore my B-755 and relatively the same cost. It what it takes to do a first class show quality restoration.
  2. 1 point
    This LTL has a 5x2x3 total 27 forward, 6 reverse from Mack. It was not uncommon for West Coast trucks. Duplex into a 3 speed Brownie. As for something to actually drive and haul the Superliner is it. It will pull anything and not break a sweat. It dynoed at 1138hp to the wheels years back and had more to go, dyno quit reading! Have to have power steering, A/C, air ride suspension, air ride cab, air ride seat, to be a little comfortable. I drive the RW, Phoenix to Macungie, no way with the LTL or B-755. they would shake my guts out! Maybe the MH when I get that one together if it were close to stock. I'm going drag racing with it. Really turned up twin turbo E9, Diesel/alcohol, with an HT754 Allison 5 speed automatic. Yes the 4 that I got are the best looking of the Mack Pack. I am not getting any more. One more thing if you want something nice, you got to pay or scrounge for parts for years, and parts are getting harder to come by. It took 10 years to get all the parts together when the B was restored about 8 years ago. I bought the LTL complete for far less than what was in it and had to redo all the sheet metal. Putting another $25K and all my work in it for what you see. It is one of about three in the world that still has all 141 aluminum castings it was born with to make it an LTL.
×
×
  • Create New...