Damicoexcavating

My truck is a single frame rail and going off my truck it's 6 spoke- I never looked on the axle for a part number I'm going off what Mack told my it came with so it could have been 5 spoke

Unless I'm mistaken or the front axle has been swapped out it's always been set up as a dump truck-will a heavier rated axle bolt bolt in as a replacement?

Knuckle is still available buts it's pricey trying to find a cheaper alternative going into the off season

My 1985 R688ST dump has broken the drivers side steering knuckle/spindle where the steering arm mount so I'm looking for either a front axle assembly Mack number faw537c (12,000 pound axle) or a knuckle part number 4qh312p2-preferably closer to Illinois if it's a entire axle.thanks

That should do it thanks

Hey guys does anyone have a wiring schematic for a 1988 dm690s? My wiring in the heater control and blower motor has been butchered up pretty good looking for some assistance in trying retain the factory wiring. Thanks in advance

Looking for a hood for a 1989 dm690s near northern Illinois-if someone has a truck they are parting out also looking sheet metal under air cleaner 815-531-2264 mike

Joliet illinois

1979 Mack superliner project/parts 300 plus engine needs rebuilt 10 speed road ranger transmission Rockwell rearends/ reyco suspension 3.70 rear end ratio Truck is a project had it running- number 6 cylinder is burnt- no time for a project right now Engine is disassembled but I have all parts to reassemble cab is in decent shape needs work on drip edge and roof in one spot Has aluminum frame Hood and doors in good shape Will consider parting out Asking $3,600 for entire truck Call 815-531-2264 with question