Jump to content

e7 427 excessive oil and water temp


dgk1

Recommended Posts

I have a 2000 cx 613 with etech 427. I just put a cam in it along with new rods,mains and oil pump. Also put a new head on it. I started it for the first time today and it has a rough idle and then smoothes out as you run it up to around 900- 1000 rpm. Figuring that's the valves need adjusting. I ran it for about 35-40 mins and the oil and water temp was almost at redline. What could cause this? What do i need to look for?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...