B61 front brake chambers

[eddeere]

Bought 2 new T 12 chambers today. The left side chamber hits the arm out of the steering knuckle. Anyone know of the part # of one that will fit, or a safe fix.

[b61mack]

I put a 12000# axle under my B61 and the smaller chambers fit, but don't know the part#s I looked at mine and the holes are up-down yours are sideways. my new chambers look like the ones you took off. the only problem I had was on the auto slack adjuster was tight on the driver side.

[carlotpilot]

fwiw i would take that old one apart clean it up put the guts out the new one in the old one paint and replace it

[thomastractorsvc]

If you cant find the smaller diameter ones do like what carlotpilot said, just clean it up replace the pancake for about $2 and you should be good.

Take the old one with they should be able to cross it if they know what they are doing

I found this looks like yours but I would have them measure it

SC09 by HALDEX
Service Chamber - Size T09

http://www.finditparts.com/products/370839/haldex-sc09?srcid=CHL01SCL010-Npla-Dmdt-Gusa-Svbr-Mmuu-K370839&gclid=CjwKEAiA8qG1BRDz0tmK0pufw3QSJACfn6olNNIdb7sA40EQ7qOYipO7F2C_4s50yRiQh5GhhfK-lhoC0X7w_wcB

[eddeere]

Thanks. I started with carlotpilot's idea. When I got the old ones apart the springs were broken. The new ones were too short. With the link from thomastractorvc I orded 2 Haldex SC 12 chambers. They will come from California and are temporary out of stock. If any one needs a type 12 as pictured let me know. Priced very reasonable.