riderman523 Posted July 3, 2015 Share Posted July 3, 2015 On my 2014 Granite the mount on the right top side of the cab that holds the stack has a small shaft riding thru a bushing that is sloppy. Not even 1 year on the road. It is so annoying to listen to as it rattles. I tried putting a piece of rubber in between the cab and the mount but it is still noisy. Any ideas? I would think it isnt worn out since its so new. Quote Link to comment Share on other sites More sharing options...
j_martell Posted July 4, 2015 Share Posted July 4, 2015 I had the one on the granite (2011) i used to drive replaced, not due to rattles, but squeeks as the cab moved. Lasted about two years. My buddy is driving it now, and just had it done again, Mack did the first one "free", but i think they payed for this one Quote Lack of planning on your part does not constitute an emergency on my part.... Link to comment Share on other sites More sharing options...
Dirtymilkman Posted July 4, 2015 Share Posted July 4, 2015 Spray some "armor all" on it. It works well for rubber squeaks Quote Link to comment Share on other sites More sharing options...
j_martell Posted July 4, 2015 Share Posted July 4, 2015 I was almost ready to just rip the f****r of the cab, flip the elbow on the "exhaust cube" behind the pass step and make it into a weed burner.....Tried all kinds of crap, just collected more crud and made noise again....never thought of amor all.it was more of a vibration from the stack wearing through the bushing at an angle from the arc of the cab moving.... 1 Quote Lack of planning on your part does not constitute an emergency on my part.... Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.