Jump to content

01 CH - Cab lights installation and sun visor


Recommended Posts

I converted an 01 CH to a dump truck and when the sleeper was removed, the cab lights and visor were also removed since it was attached. I've bought a new sun visor (not chrome, of course) but looks difficult to put on since there are no pre-set holes to screw it into. Plus, the can lights also look tricky since there's only one wire hanging off from where it was connected to sleeper lights. There's rubber pieces from where it looks like the lights go but no wires. Any advice will really help on how to get this done. Thanks

Link to comment
Share on other sites

Get yourself a nut insert tool,puts a 1/4 blind nut in the cab then you thread the bolt in tight, napa sells the kit is fairly cheap, as for the lights you can do the same thing and feed the lights to that one wire with 1 wire running across.when you do the visor lay it on the cab and mark your holes and drill,same for lights

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...