firenut Posted October 21, 2014 Share Posted October 21, 2014 Hello all... pretty new here and am looking for information on a driveshaft for 1950 mack... specifically does the shaft have to line up with the rear axle in any specific way or is it as simple as lining up the bolt holes and securing? Thanks for any info you can provide. Quote Link to comment Share on other sites More sharing options...
gearhead204 Posted October 22, 2014 Share Posted October 22, 2014 since I don't know hat you are doing fully I would suggest trying "Spicer drive train products" search and they do a good job of explaining drive shaft do"s and don'ts. hope this helps Quote Link to comment Share on other sites More sharing options...
j_martell Posted October 22, 2014 Share Posted October 22, 2014 What he said..... Lots of good help here if we know the details... Quote Lack of planning on your part does not constitute an emergency on my part.... Link to comment Share on other sites More sharing options...
j hancock Posted October 22, 2014 Share Posted October 22, 2014 You want the u joints to line up. Just check it in case someone has taken the shaft apart at the slip joint.The old style yoke with all the bolts "usually" can bolt up any way. Take a look and see if someone stamped marks for putting it back together. If not marked, should be good to go. 2 Quote JimIt doesn't cost anything to pay attention. Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.